Folder both outer and inner braid down around jacket and leave inner foil in contact with dielectric. Home Network Wiring and Setup Chapter 3. I haven't done that many cables and I can't say I'm overly consistent with how I strip the cable. Applications The CPT Series of cable stripping tools strip the jacket and cut back the braid and dielectric to the proper dimensions on braided and braid-replacement drop cables, including standard single through quad shielded RG-6, , -7, and cables. If you can't get the connector on without folding the braid back, I'd say you're probably using the wrong connector.
Belden PSA59/6 Adjustable Cable Stripper With RG6 Flaring Tool
The stripping tools I have seen and used all have to be adjusted before they produce the right cuts on the particular brand of coax you are using. We promise to never spam you, and just use your email address to identify you as a valid customer. The compression tool and cutter thing are solid, though. I know that was a chancy guess, but I went with it. Copper is a better conductor than aluminum.
Rg6 Cable Stripping Machine Wholesale, Cable Strip Suppliers - Alibaba
The middle blade should be adjusted to cut through all layers except the center lead. Amazon Inspire Digital Educational Resources. I see what you did there! But, due to the gaps inherent in the braided copper construction, the level of coverage is lacking. You can buy these kinds of strippers at some electrical suppliers or on eBay by searching "rotary rg6 rg59 stripper" or "rotary rg6 rg59 stripper 3 blade" for the slightly more expensive but better 3 blade strippers. The blade part is also a replaceable cartridge.
I misread initially - I never fold any braid down. The stripper one is a little bit flimsy but works fine. Give it a little tug to make sure it's secure. I had to make a spacer for the compression tool so it could fully compress the EX6XL fittings I have but it worked perfect for the fittings that came with the kit. Clear cable illustration on top of Coaxial cable stripper for cable placement and embossed arrow for spin direction. The connectors just don't have the room inside for the cable WITH 4 layers of shielding on them. When it wears out no biggie, it's a throw away tool.